30
Maintenance Schedule
The following items are only a general guideline for maintaining your Mudd-Ox Vengeance. Read this entire manual
for detained information on inspecting, maintaining and replacing components.
• Axle Bearings: Grease every 25 hours or after each use in water/mud, whichever comes first.
• Chain Lubrication: Inspect before each use. Lubricate after entering mud, water, or after raining/washing in-
side the Mudd-Ox. Keeping chains lubricated enables them to move smoothly, prevents rust and premature
wear. Simply spray lubricant over entire chain surface area
• Engine: See specific engine service manual.
• Hydraulic Fluid: Initial filter change after 500 hours. Then, full oil change every 3,000 hours.
• Tires: Verify pressures before each use.
Listed are the oil capacities for the Mudd-Ox XL. See specific engine service manual for details on your specific
engine model. Always ensure the vehicle is correctly prepared and the fluid levels are within tolerance before
each use.
Engine Coolant 2.25 gallons
50/50 Glycol Antifreeze/Water
Engine Oil 6.34 quarts
See Engine Manual
10.5 gallons w/ rear roll bar
AW-46
GasolineFuel Tank
Hydraulic Oil
To Next Page
Loading...