CLEANING THE SPRAY ARMS:
The spray arm can be easily removed for periodic
cleaning of the nozzles to prevent possible clogging
and limescale buildup.
Remove the spray arm by grasping the middle and
pull upwards. Wash the spray arm under running
water and carefully reinstall making sure the rotary
movement is in no way impeded.
NOTE: If spray arms water holes are blocked, use a
thin wire to remove the blockages out of the holes,
or flush the holes with water.
Please take frost protection measures during the winter months. Please follow
these procedures after each wash:
1. Turn off the dishwasher.
2. Turn off the water supply and disconnect the water inlet hose from the back of
the unit.
3. Drain water from the inlet hose and inlet port - use a pan to catch the water.
4. Reconnect the water inlet hose to the inlet port.
5. Remove the Stainless steel filter (see “Filter System” above), and use a sponge
to absorb the water in the sump.
NOTE: if your dishwasher cannot operate due to ice, please contact a service
professional.
PROTECT AGAINST FREEZING:
1. Rotate the filter assembly counterclockwise, then
lift upward.
2. Remove the stainless steel filter from the filter
assembly.
3. Rinse the filter assembly and stainless steel filter
with running water.
4. After cleaning, position the stainless steel filter
back to its place. Insert the filter assembly back into
the stainless steel filter, and turn clockwise to lock in
place.
17
To Next Page
Loading...
