PREPARATION FOR STORAGE:
It is recommended you run a wash cycle with the dishwasher empty. Disconnect
from power and turn off the water supply. Remove any water remaining in the sump
area with a sponge. Leave the door slightly open, this will help the door seals to last
longer and prevent odors from forming inside the dishwasher.
MOVING THE DISHWASHER:
If the dishwasher must be moved, try to keep it in the upright position. Never
position the dishwasher on its side or upside down.
TROUBLESHOOTING:
Thermistor short circuit
Thermistor short circuit
The appliance is not
heating
Please contact authorized service provider.
Please contact authorized service provider.
1. Ensure tableware is placed correctly. Water
can get trapped in a plate/bowl.
2. Please contact authorized service provider.
Please contact authorized service provider.
1. Lean the appliance about 30°to 45°to pour
out excess water from the bottom plate.
2. Check if the drainage pipe is placed too high.
3. Check if the pipe is blocked.
4. Check if the appliance is properly
positioned/level.
5. Exclude above causes, and and restart the
appliance.
Please contact authorized service provider.
Please contact authorized service provider.
1. The valve is not fully opened.
2. Small inflow and low water pressure.
3. Start-up multiple times in case of water
shortage.
4. Please contact authorized service provider.
Error
code
Cause Solution
Overflow
Inlet valve failure
Water inflow abnormal
Heating function abnormal
18
To Next Page
Loading...