Replace fuse or reset circuit breaker. Remove
any other appliances sharing the same
circuit with the dishwasher.
Make sure the dishwasher is turned on and
the door is closed securely. Make sure the
power cord is properly plugged into the wall
socket.
Close door completely and make sure it is
latched.
Check drain hose.
Check filter system.
Check sink to make sure it is draining well. If
sink is clogged, you may need a plumber.
Use only dishwasher detergents to avoid
suds. If suds occurs, open the dishwasher
and let suds evaporate. Close the door then
Start the “Rapid” wash cycle. Repeat if
necessary.
ALWAYS wipe up rinse-aid spills immediately.
DO NOT use detergents with colorants or
dyes.
To clean the interior, use a damp sponge
with dishwasher de-tergent and wear rubber
gloves. Never use any other cleaner than
dishwasher detergent for the risk of foaming
or suds.
Only put corrosion resistant items in the
dishwasher.
Run the Rapid wash cycle without any dishes
or utensils in the dishwasher after adding
dishwasher detergent.
If you are able to, interrupt the program and
rearrange the items which are obstructing
the spray arm.
If you are unable to interrupt the program, fix
the spray arm position after cycle is
complete.
If you are able to, interrupt the program and
rearrange items in the dishwasher.This has
no influence on dishwasher function.If in
doubt, contact a suitably qualified plumber.
Detergent with
colorant was used.
Hard water
minerals.
Spilled Rinse Aid.
The spray arm is
hitting an item in the
basket.
Fuse blown or
circuit breaker
tripped.
Power supply not
turned on.
Door of dishwasher
not properly closed.
Kink in drain hose.
Filter is clogged.
Kitchen sink
clogged.
Stained tub
interior
White film on
inside surface
Problem SolutionPossible Causes
Technical ProblemsGeneral Problems
Noise
Dishwasher
does not
start
Water not
pumped from
dishwasher
Suds in the
tub
Improper
detergent.
A program was not
run after dishwasher
detergent was added.
Traces of detergent
have gotten into the
wash cycle.
Item inside is loose.
This may be caused
byon-site installation
or the cross-section
of the piping.
Cutlery is not
corrosion resistant.
Rust stains
on cutlery
Knocking noise
inside the wash
cabinet
Rattling noise
in the wash
cabinet
Knocking noise
in the water
pipes
19
To Next Page
Loading...
