Multitech MMCModem GPRS (MTMMC-G) - Customer Service Profile +WCSP; Customer Storage Mirror +WMIR; Change Default Player +WCDP

Chapter 13 – Specific AT Commands
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I) 130
Customer Service Profile +WCSP
Description: This indication tells whether or not a service is accessible to the customer. This command is the
response to the AT+CPHS 2,7,<service>] command.
Values: <service> value indicating the CSP field to display (See Codes and Values in the Appendix).
<status>
0 service is not customer-accessible
1 service is customer-accessible
Note: The field Alternate Line Service (CPHS Teleservices Group) sets the ALS feature at
initialization.
Syntax: Command Syntax: AT+CHPS=2,7,<service>
Response Syntax: +WCSP: <service>,<status>
Command Possible responses
AT+WCSP=? ERROR
AT+WCSP? ERROR
AT+CPHS=2,7 +CME ERROR: 3
Note: Syntax error
AT+CPHS=2,7,9
Note: Get current status of Barring All Outgoing Calls
+WCSP: 9,1
OK
Note: Barring or All Outgoing Calls is
customer accessible
AT+CPHS=2,7,11
Note: Get current status of Barring All Outgoing
International Calls
+WCSP: 11,1
OK
Note: Barring or All International Outgoing
Calls is customer accessible
AT+CPHS=2,7,2
Note: Get current status of Call Forwarding on User Busy
+CME ERROR: 3
Note: CPHS feature is not allowed
AT+CPHS=0,7
Note: Deactivatation of CPHS Information
OK
Note: No effect
Customer Storage Mirror +WMIR
Description: This command allow you to make a mirror copy of the current configuration parameters in the
EEPROM. In the case of a memory problem for the storage: if a customer mirror already exists, this one
will be restored. Otherwise, the default mirrored parameters are restored.
Warning: This command should be used only on special advice from a Technical Support person.
Values: No parameters
Syntax: Command syntax: AT+WMIR
Command Possible responses
AT+WMIR=? OK
AT+WMIR
Note: Build the Customer Mirror
OK
Change Default Player +WCDP
Description: This command allows the default melody player to be selected.
Values: <player>
0 Buzzer
1 Speaker
Syntax: Command syntax: AT+WCDP = <player>
Command Possible responses
AT+WCDP=? +WCDP: (0-1)
OK
AT+WCDP=0
Note: Select the buzzer
OK
AT+WCDP? +WCDP: 0
OK