Chapter 13 – Specific AT Commands
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I) 135
Reset +WRST
Description: This command resets the modem after the time specified by the <delay> parameter.
Values: <val1>
0 timer reset is disabled
1 timer reset is enabled
<Delay> specify the time for reset
Range “000:00”- “168:59” (format hhh:mm)
<RemainTime> time before next reset
Range “000:01”- “168:59” (format hhh:mm)
Syntax: Command syntax: AT+WRST =<Mode>,<Delay>
Response syntax: +WRST: <Mode>,<Delay>,<RemainTime>
Command Possible responses
AT+WRST=? OK
AT+WRST=0
Note: Disable timer
OK
AT+WRST=1,”001:03”
Note: Enable timer and put delay at 1 hour 3
minutes
OK
AT+WRST? +WRST: 1,”001:03”,”001:01”
OK
Note: Timer activated to reset after 1 hour and 3
minutes. At this point, 1 hour and 1 minute remain
before next reset.
Set Standard Tone +WSST
Description: This command sets and gets the sound level of the Standard Tones.
Values: <sound level> Range [0; 15]
0 Maximum volume (default)
15 Minimum volume
<ring tone level> Range [0; 15]
0 Maximum volume (default)
15 Minimum volume
Syntax: Command syntax: AT+WSST=[<sound level>][,<ring tone level>]
Command Possible responses
AT+WSST=0
Note: Set volume to Maximum
OK
AT+WSST=15
Note: Set volume to Minimum
OK
AT+WSST=,5
Note: Set ring tone level to 5
OK
AT+WSST?
Note: get current standard tones
sound level
+WSST: 15,5
OK
Note: current standard tones level is 15
(minimum), and ring tone level is 5.
AT+WSST=?
Note: supported parameters
+WSST: (0-15),(0-15)
OK
To Next Page
Loading...
