Multitech MMCModem GPRS (MTMMC-G) - Page 144

Chapter 14 – SIM Toolkit
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I) 144
Values when CmdType=1 (Display text)
<Prior>
0 Normal priority of display
1 High priority of display
<Text> Text to display in ASCII format
<ClearMode>
0 Clear message after a delay (3 seconds)
1 Wait for user to clear message
Values when CmdType=2 (Get Inkey)
<Format>
0 Digit (0-9, *, #,and +)
1 SMS alphabet default
2 UCS2
<HelpInfo>
0 No help information available
1 Help information available
<TextInfo> Text information in ASCII format
Values when CmdType=3 (Get Input)
<Format>
0 Digit (0-9, *, #,and +)
1 SMS alphabet default
2 UCS2
3 Unpacked format
4 Packed format
<EchMode>
0 Echo off
1 Echo on
<SizeMin> (1-255) Minimum length of input
<SizeMax> (1-255) Maximum length of input
<HelpInfo>
0 No help information available
1 Help information available
<TextInfo> Text information in ASCII format
Values when CmdType=4 (Setup Call)
<Type>
0 Set up call but only if not currently busy on another call
1 Set up call, putting all other calls (if any) on hold
2 Set up call, disconnecting all other calls (if any)
<CalledNb> Called party number in ASCII format
<SubAdress> Called party sub-address in ASCII format
<Class>
0 Voice call
1 Data call
<Alpha Id>
Values when CmdType=5 (Play tone)
<ToneType>
0 Tone Dial
1 Tone Busy
2 Tone Congestion
3 Tone Radio ack
4 Tone Dropped
5 Tone Error
6 Tone Call waiting
7 Tone Ringing
8 Tone General beep
9 Tone Positive beep
10 Tone Negative beep
<TimeUnit>
0 Time unit used is minutes
1 Time unit used is seconds
2 Time unit used is tenths of seconds
<TimeInterval> (1-255) Time required expressed in units
<TextInfo> Text information in ASCII format