Multitech MMCModem GPRS (MTMMC-G) - Page 169

Chapter 15 – GPRS Commands
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I) 169
Syntax: Command Syntax: AT+WGPRS=<mode>,<parameter>,[<cid>],[<class>]
Command Possible Responses
AT+WGPRS=?
+WGPRS: <mode>, <parameter1>,[<cid>]
[<CR><LF>+WGPRS: <mode>,
<parameter>,[<cid>]
[...]]
OK
AT+WGPRS? +WGPRS:<mode>(list of supported
<parameter>),[(list of supported
<cid>)][<CR><LF>+WGPRS:<mode>(list of
supported <parameter>),[(list of supported
<cid>)] [...]]
OK
AT+WGPRS=2,1,3
Note: Set ACTIVABLE to ON on PDP context
3
OK
AT+WGPRS=7,1
Note: Set automatic re-attachment to the
network and reactivation of PDP context in
case of change of operator for MCC/MNC
OK
AT+WGPRS=4,,,18
Note: Choose GPRS multislot class 8
OK
AT+WGPRS=?
Note: Request range of values
AT+WGPRS: (0-7),(0-1),(0-4),(2,8,10,12)
OK
AT+WGPRS?
Note:
− Automatic re-attachment at init not activated
− Automatic reactivation of PDP context at init
not activated
− 3 PDP contexts and automatic reactivation
only for cid 1
− PPP silent mode activated
− GPRS class is 8
− GPRS slow connect activated
− PPP filtering activated
− Automatic re-attachment and PDP
reactivation at operator board area
+WGPRS: 0,0
+WGPRS: 1,0
+WGPRS: 2,1,1
+WGPRS: 2,0,2
+WGPRS: 2,0,3
+WGPRS: 2,0,4
+WGPRS: 3,1
+WGPRS: 4,8
+WGPRS: 5,1
+WGPRS: 6,1
+WGPRS: 7,1
OK