DEFINING TUNNELS
60 MultiConnect
®
rCell 100 MTR-LTE User Guide
When using Static Key, the OpenVPN tunnel is created between only two end-points, the client and server. You
cannot connect more than one client to the server in this mode. Remote Network Route must be specified in both
configurations, client and server, in order to establish the connection between subnets.
To add an OpenVPN Server using Static Key:
1. Go to Tunnels > OpenVPN Tunnels > OpenVPN Tunnel Configuration.
2. Click Add Tunnel.
3. Enter the Name.
4. Select the Type as SERVER from the drop-down.
5. You can also enter an optional Description.
6. Click Next.
7. Enter the following fields (using STATIC KEY as Authorization Mode):
a. Interface Type as TUN from the drop-down.
b. Authorization Mode as STATIC KEY from the drop-down.
c. Protocol as UDP.
d. Local Address as DEFAULT.
e. Port number.
f. Remote Address as DEFAULT.
g. LZO Compression as ADAPTIVE from the drop-down.
h. Hash Algorithm as DEFAULT.
i. Encryption Cipher as DEFAULT.
j. Generate and enter the Static Key PEM (required). Both server and client must use the same static
key. See example below:
-----BEGIN OpenVPN Static key V1-----
3f4c9113b2ec15a421cfe21a5af015bb967059021c1fd6f66ecfd00533d967237875215e20e80a2d59efd
79148d6acdea9358dcafe0efdbb54003ff376c71432dd9d16f55e7d8917a32bfe07d61591b7bbb43c7ba
d214482b8547ec9dca8910f514d9f4270ccaeff1a79852ae27c1c307c9dc3c836d1c380bece3c70fd2104
e1968ed29b6c3388719226f959f69f9be43688ed27bc3a4dbc83f640370524b47bb871816af79586d07
08781fad384480d0609b11c31d27baa6e902d29277a474e3e2785a8410d595c0f9c75312375b4bd098
76e1a47a598e114749a09c35f098e9123015c2795c702e4a346a8bccd00305c7cb30beef66ad33f43dac
c2e662128
-----END OpenVPN Static key V1-----
8. Click Next.
9. Remote Network Routes create a route from the server network to the client network. This allows the
server to get access to the client’s network. In the OpenVPN Tunnel dialog box, under Remote Network
Routes:
a. Choose an available Saved Network as your remote network route from the drop-down if desired
(optional).
b. Or enter the Remote Network Route (should be the client subnet). For example, if the client IP
address is 192.168.3.1, enter 192.168.3.0.
c. Enter the Remote Network Mask (usually 255.255.255.0).
d. Click Add Route.
To Next Page
Loading...
