Multitech MultiModem MT5600ZDX - Page 32

MT5600ZDX Owner's Manual
32
Command: B n Communication Standard Setting
Values:
n = 0 or 1
Default: 0 and 1
Description: B0 Select ITU-T V.22 mode when modem is at 1200 bps.
B1 Select Bell 212A when modem is at 1200 bps.
Command: D
s Dial
Values:
s = dial string (phone number and dial modifiers)
Default: none
Description: Dial telephone number
s , where s may up to 40 charac-
ters.
Dial string modifiers:
0-9 DTMF digits 0 to 9
* The "star" digit (tone dialing only)
# The "gate" digit (tone dialing only)
A-D A, B, C, and D DTMF digits. Country specific; some
countries may prohibit these digits.
L Redial last number. (Must be placed immediately
after ATD.)
P Pulse-dial following numbers in command.
T Tone-dial following numbers in command
V Switch to speakerphone mode and dial the following
number. Use ATH command to hang up.
W Wait for a new dial tone before continuing to dial. (X0,
X1, X3, or X4 must be selected.)
S Dial a telephone number previously stored using the
&Zn=x command (see &Zn=x command for further
information). The range of n is 0-3.
, Pause during dialing for time set in register S8.
; Return to command mode after dialing. (Place at end
of dial string.)
! Hook flash. Causes the modem to go on-hook for
one-half second, then off-hook again (time specified
in S29).
@ Wait for quiet answer. Causes modem to wait for a
ringback, then 5 seconds of silence, before process-
ing next part of command. If silence is not detected,
the modem returns a NO ANSWER code.
$ Wait for credit card dialing tone before continuing
with the dial string (wait contingent on S7 setting).
^ Toggles data calling tone enable/disable: applicable
to current dial attempt.