MT5600ZDX Owner's Manual
64
Result Codes
When the MultiModemZDX receives an AT command from the terminal
or PC, the MultiModemZDX tries to execute the command, then sends
a status message to the PC or terminal which reports the "results" of
the command (hence the name "result codes"). The MultiModemZDX
Command mode provides you with several responses, or
“Result
Codes”
, that provide visual responses during Command mode
operation. These Result Codes are displayed on your PC's video
monitor.
Table 3-4 Result Codes
Terse Verbose Description
0OK
Command executed
1 CONNECT
Modem connected to line
2 RING
Ring signal detected
3 NO CARRIER
Carrier signal lost or not
detected
4 ERROR
Invalid command
5 * CONNECT 1200
Connected at 1200 bps
6 NO DIALTONE
No dial tone detected
7 BUSY
Busy signal detected
8 NO ANSWER
No answer at remote end
10 * CONNECT 2400
Connected at 2400 bps
11 * CONNECT 4800
Connected at 4800 bps
12 * CONNECT 9600
Connected at 9600 bps
13 * CONNECT 7200
Connected at 7200 bps
14 * CONNECT 12000
Connected at 12000 bps
15 * CONNECT 14400
Connected at 14400 bps
16 * CONNECT 19200
Connected at 19200 bps
17 * CONNECT 38400
Connected at 38400 bps
18 * CONNECT 57600
Connected at 57600 bps
19 * CONNECT 115200
Connected at115200 bps
22 * CONNECT 75TX/1200RX
Connected at V.23 Originate
23 * CONNECT 1200TX/75RX
Connected at V.23 Answer
24 * DELAYED
Delay is in effect for the dialed
number
32 * BLACKLISTED
Dialed number is blacklisted
33 FAX
Connected FAX mode
35 DATA
Connected DATA mode
40 * CARRIER 300
0-300 bps Data Carrier Detected
To Next Page
Loading...
