Multitech MultiModem MT5600ZDX - Page 63

Chapter 3 - AT Commands, S-Registers and Result Codes
63
Register Unit Range Default Description
S95 - Extended Result Codes
The bits in this register can be set to override some of the Wn command
options. A bit set to a 1 in this register will enable the corresponding result
code regardless of the Wn setting. Also, refer to Table 3-4.
Default: 0
Bit 0 CONNECT result code indicates DCE speed instead of DTE
speed.
Bit 1 Append/ARQ to CONNECT XXXX result code in error-correction
mode (XXXX = rate; see Table 3-4).
Bit 2 Enable CARRIER XXXX result code (XXXX = rate; see
Table 3-4.
Bit 3 Enable PROTOCOL XXXX result code (XXXX = protocol
identifier; see Table 3-4).
Bit 4 Reserved.
Bit 5 Enable COMPRESSION result code (XXXX = compression
type; see Table 3-4).
Bit 6 Reserved.
Bit 7 Reserved.