Multitech MultiModem MT5600ZDX - Page 34

MT5600ZDX Owner's Manual
34
Command: L n Monitor Speaker Volume
Values:
n = 0, 1, 2, or 3
Default: 1
Description: L0 Select low volume.
L1 Select low volume.
L2 Select medium volume.
L3 Select high volume.
Command: M
n Monitor Speaker Mode
Values: n = 0, 1, 2, or 3
Default: 1
Description: M0 Speaker always off.
M1 Speaker on until carrier signal detected.
M2 Speaker always on when modem is off-hook.
M3 Speaker on until carrier is detected, except while dial-
ing.
Command: N
n Modulation Handshake
Values:
n = 0 or 1
Default: 1
Description: N0 Disables auto-mode (automatic modulation negotia-
tion); uses connection speed specified in S37. (Equiv-
alent to +MS <automode> subparameter to 0.)
N1 Enables auto-mode. (Equivalent to +MS <automode>
subparameter to 1.)
Command: O
n Return Online to Data Mode
Values: 0 or 1
Default: None
Description: O0 Enters on-line data mode without a retrain. Handling is
determined by the Call Establishment task. Typically, if
a connection is established, this command connects the
DTE back to the remote modem after an escape (+++).
O1 Issue a retrain and return to online data mode.
Command: Q
n Enable/Disable Result Codes
Values:
n = 0 or 1
Default: 0
Description: Q0 Enable Result Codes.
Q1 Disable Result Codes.