Multitech MultiModem MT5600ZDX - Page 41

Chapter 3 - AT Commands, S-Registers and Result Codes
41
Command: &V1 Display Last Connection Statistics
Values: n/a
Description: Displays the last connection statistics in the following
format (shown with typical results):
TERMINATION REASON...... LINK DISCONNECT or
LOCAL REQUEST
Last TX Data Rate ...... 33600 BPS
Highest TX Data Rate ...... 33600 BPS
Last RX Data Rate ...... 28800 BPS
Highest RX Data Rate ...... 28800 BPS
Error Correction Protocol ... LAPM
Data Compression ..... V42Bis
Line Quality ...... 030
Highest SPX RX state ...... 068
Highest SPX TX state ...... 067
Command: &W
n Store Current Configuration
Values:
n = 0 or 1
Default: None
Description: &W0 Store active modem settings in NVRAM as profile 0.
&W1 Store active modem settings in NVRAM as profile 1.
Command: &Y
n Select Stored Configuration for Hard Reset
Values:
n = 0 or 1
Default: none
Description: &Y0 Select stored configuration 0 on power-up.
&Y1 Select stored configuration 1 on power-up.
Command: &Z n = x Store Telephone Number
Values:
n = 0, 1, 2, or 3 memory locations
x = Dialing string
Default: None
Description: Stores telephone dial string
x in memory location n .
Dial the stored number using the command
ATDS=n .