MT5600ZDX Owner's Manual
58
Register Unit Range Default Description
S36
Bit-Mapped Options Status (Indicates the status of command Op-
tions.) LAPM Failure Control Default: 7
Bits 0-2 This option indicates what should happen upon a LAPM failure.
These fallback options are initiated immediately upon connection if S48 = 128.
If an invalid number is entered, the number is accepted into the register, but
S36 will act as it the default value has been entered.
0 = Modem Disconnects.
1 = Modem stays on-line and a Direct mode
connection is established.
2 = Reserved
3 = Modem stays on-line and a Normal
mode connection is established.
4 = An MNP connection is attempted and if
it fails, the modem disconnects
5 = An MNP connection is attempted and if it fails, a Direct mode
connection is established
6 = Reserved
7 = An MNP connection is attempted and if
it fails, a Normal modem connection is established (Default)
Bits 3-7 Reserved
S37
Bit-Mapped Options Status (Indicates the status of command Op-
tions.) Desired DTE Connection Speed Default: 0
When the Nn command is issued or the S37 register value is modified, the +MS
command subparameters are updated to reflect the speed and the modulation
specified bit the S37 value. For Example:
If N0 command is active, S37 = 10 updates the +MS command subparameters
to reflect +MS = 10,1,300,12000.
IF N1 command is active, S37 = 10 updates the +MS command subparame-
ters to reflect +MS = 10,0,12000,12000.
S37 is not updated by the +MS command.
Use of the +MS command is recommended instead of the Nn and S37 = x
commands. Nn and S37 = x commands are supported for compatibility with
existing communications software.
Bits 0-4 Desired line connection speed. If an invalid number is entered, the
number is accepted into the register, but S37 will act as if the default value has
been entered.
To Next Page
Loading...
