Multitech MultiModem MT5600ZDX - Page 60

MT5600ZDX Owner's Manual
60
Register Unit Range Default Description
S40 Bit-Mapped Options Status (Indicates the status of command Op-
tions.) Default: 104
Bit 0-1 MNP Extended Services (-Kn)
0 = Disable Extended Services (-K0) --Default
1 = Enable Extended Services
2 = Enable Extended Services
Bit 2 Reserved
Bit 3-5 Break Handling (\Kn)
0 = \K0
1 = \K1
2 = \K2
3 = \K3
4 = \K4
5 = \K5--Default
Bit 6-7 MNP Block Size (\An)
0 = 64 characters (\A0)
1 = 128 characters (\A1)--Default
2 = 192 characters (\A2)
3 = 256 characters (\A3)
S41 - General Bit Mapped Options Status Indicates the status of command
options. Default: 195 (C3h)
Bits 0 -1 Compression selection (%Cn)
0 = Disabled (%C0)
1 = MNP 5 (%C1)
2 = V.42 bis (%C2)
3 = MNP 5 and V.42 bis (%C3)--Default
Bits 2, 6 Auto retrain and fallback/fall forward (%En)
Bit 6 Bit 2
0 0 = Retrain and fallback/fall
forward disabled (%E0)
0 1 = Retrain enabled (%E1)
1 0 = Fallback/fall forward enabled
(%E2)--Default
Bit 3 Reserved
Bits 4-5 Reserved
Bit 7 Reserved