Page4of17
IMC08 Maintenance Manual
Version 1.01
1.0. Overview
Thank you for purchasing our banknote counters IMC08.
After starting the machine, it will go on self-check automatically. If the preset window shows the error code or
tell you to clean the sensors, generally speaking, it is because of dust on the surface or sensor blocked by notes.
So please clear the dust on the surface with brush or soft cloth, or take the notes away. Then restart the machine.
This document describes the error handling guideline and the maintenance manual.
ATTENTION:
1) The unit should always be turn off and disconnected from its power cord before cleaning. DO NOT use
solvents such as thinner, alcohol, etc. to clean the machine.
2) Most operational problems can be avoided by regular care and preventative maintenance. Taking regular care
of the machine will significantly increase its lifetime.
3) To avoid problems, make sure there are no metal clips or rubber bands in the bills being counted. Be sure to
follow the proper procedure for loading the hopper.
4) For best results, it is recommended that to use an air duster and a soft bristle brush to remove any dust or
debris from the interior of the unit. When not using the machine for an extended period time, cover it with a
dust cover (not included with the unit) to prevent dust from settling inside.
5) All parts of the machine need daily care and cleaning. Pay close attention to the sensors, which are delicate
components. If any dust or other foreign matter adheres to the sensors, it may cause various problems during
operation of the machine.
To Next Page
Loading...
