4. Transport, delivery inspection and storage
4.1. Transport
Transport the dehumidifier by carrying it by its handle or in the original packaging.
The unit must always be placed in an upright position during transport. Failure to comply with this can
cause the unit to malfunction.
The power cable should be rolled up and placed under the handle.
Rolled up power cable
4.2. Delivery inspection
• Do an inspection of the delivery and compare with the delivery note, order confirmation or other deliv-
ery documentation. Make sure that everything is included and nothing is damaged.
• Contact Munters immediately if the delivery is not complete or damaged in order to avoid installation
delays.
• Any damage to the packaging must be documented with photos before the packaging is removed.
• Remove all packaging material from the unit, and make sure that no damage has been made during
transportation.
• Any damage to the unit must be documented with photos.
• Any visible damage must be reported in writing to Munters within 3 days and prior to installation of the
unit.
• Discard the packaging material according to local regulations.
4.3. Storage
CAUTION
Always unplug the unit from the power supply when not in use.
Follow these instructions if the dehumidifier is to be stored prior to installation:
• Place the dehumidifier in an upright position on a horizontal surface.
• Re-use the packaging material to provide protection for the unit.
• Protect the dehumidifier from physical damage.
• Store the dehumidifier under cover and protect it from dust, rain and aggressive contaminants.
ComDry M190Y Dehumidifier
9
To Next Page
Loading...
