Munters Communicator 2.0 - 3.9 Connecting to Peripheral Devices; 3.10 Connecting the T-Box to External Devices

© Munters AB, 2020 Trio 12
3.9 Connecting the Communicator 2.0 to a Peripheral Device
• If required, connect a screen and key board to the Communicator 2.0 (via the four
USB or single HDMI ports).
NOTE: You’ll need to connect the Communicator 2.0 to these devices for the Activation.
Figure 9: Connection to Peripherals
3.10 Connecting the T-Box to External Devices
If required, connect the T-Box to external devices and an ELS system (Figure 11).
1. Plug the 25 plug connector into the T-Box.
Figure 10: Communicator 2.0 – Junction Box – Controller Block Diagram
2. Wire the devices as shown in Figure 11.