© Munters AB, 2020 Trio 27
5.3.2
R
ESPONDING TO A
T
EXT
M
ESSAGE
This section details how to respond to a text message sent from Communicator 2.0 to a
mobile phone. The response can reset a siren, an alarm, or acknowledge the messages.
•
Resetting the Siren
•
Resetting the Alarm
•
Acknowledging a Message
5.3.2.1
Resetting the Siren
NOTE: After typing the text message, press the 'Send' button to send it to the
Communicator 2.0.
In the procedures below, the
highlighted text
shows the SMS text to be sent.
• Resetting the Siren of One House
!RX > 'Send SMS' to the Communicator 2.0 cell phone number.
! = Start of message
R = Reset
X = Represents house number (can be any positive number from 1-64)
• Resetting the Siren of Several Houses
!RX#X#X > 'Send SMS' to the Communicator 2.0 cell phone number
! = Start of message
R = Reset
X = Represents house number (can be any positive number from 1-64)
# = Sign separates between every house number
• Resetting the Siren for All Houses
!RALL > 'Send' to the Communicator 2.0 cell phone number
! = Start of message
R = Reset
ALL = Can be typed both in capital letters or small letters.
5.3.2.2
Resetting the Alarm
To reset all the alarms, send the following text message:
!C > 'Send' to the Communicator 2.0 cell phone number
! = Start of message
C = Communicator
5.3.2.3
Acknowledging a Message
Communicator 2.0 continues to send alarms until an acknowledgement is sent.
• Requesting a Response for Every Sent Text Message
!AON > 'Send' to the Communicator cell phone number
! = Start of message
A = Acknowledgement
To Next Page
Loading...