Munters Communicator 2.0 - Page 20

© Munters AB, 2020 Trio 20
3. Edit the following parameters:
o
Alarm Report Delay: To prevent you from being overloaded with insignificant
alarms, you can define the amount of time an alarm condition must continue
before an alarm is sent.
o
User Gap Time: Define the delay time (if any) between messages sent to the
next person on the list (see the Priority setting).
o
Message Repeat Delay: Alarms must be acknowledged or messages are
resent to the list. Define the amount of time in which acknowledgment must
take place before resending messages.
o
Test Message Time: A test message can be sent daily to ensure that message
transmission is operating properly. This parameter sets the time that this
message is sent.
o
Country of installation: Choose from the drop down list.
o
Generator Ip Address (US customers only): Users having a backup generator
connected to the Communicator 2.0 can enter the generator’s IP address.
Communicator 2.0 will transmit any alarms from the generator.
o
Phone Line alarm: Enable sending an alarm if the phone line is disconnected.
o
Line-Out Volume: Define the call volume.
NOTE: The above two parameters require telephony connectivity to be enabled.
o
Voice Speech Speed: Define the text-to-speech playback speed.
o
About: These read-only parameters provide data for service technicians.
4. Click Save.