© Munters AB, 2020 Trio 24
1. Click the Digital Input tab.
2. Fill in the following fields:
o
Text message: Enter the text to be sent to the contact(s).
o
Notification delay: Minimum time required to pass before a message is sent.
o
NC/NO: Checking this box means that the contact is Normally Closed.
NC means “Normally Closed”. If there is a change from the usual state
(device opens), an alarm occurs.
NO means normally open. If there is a change from the usual state
(device closes), an alarm occurs.
o
Allow to Reset:
When this function is not checked, Communicator 2.0 sends a message
to every contact (in the order given in the priority list) when an alarm is
generated.
When checked, Communicator 2.0 sends a message to the first person
in the priority list. If that person acknowledges the message, no further
messages are sent. If the person does not acknowledge the message,
Communicator 2.0 repeats the process and sends a message to the
second person on the list.
o
Active: When checked the alarm function for that digital input is enabled.
To Next Page
Loading...
