16 | © Munters AB, 2019
Step 3
Attach Central Pulley to Hub using (4) Bolts [F] and Nuts [G] and tighten to 14 Nm. See Figure 3.
Figure 3
Step 4
Rotate the Central Support on the saw horses so the Motor Slide is pointing up. Then slide the Waterproof Distance Piece
[L] over the hub shaft as shown in Figure 4. Attached the Pulley/Hub Assembly to the Central Support using (1) Hex Nut
[K] and tighten to 60 Nm. See Figure 4. Then place the Cup Cover Nut [M] over the Hex Nut and fasten in place with (1)
Tapping Screw [B]. See Figure 4. Set aside the Support Assembly for use in a later step.
Figure 4
To Next Page
Loading...
