Muratec MFX-3510 - Introduction to Advanced Functions

2-10 Advanced copy functions
1
Load the document.
2
Press the mode change key to change to copy mode.
3
Press <Advanced>.
4
Select “Duplex Copy”, and press [Enter].
5
Select “1  2 sided”, and press [Enter].
Select “OFF” to deselect the setting.
6
Select “Short Edge” or “Long Edge”, and press [Enter].
7
Press <Start>.
•When you have loaded the document on the automatic document feeder, this will complete
the operation.
•When you have loaded the document on the document glass, the following message will
appear when the first page of the document is scanned.
8
Load the next page of the document, and press <Start> or [Scan NextPage].
•Repeat this step until all pages of the document are scanned.
•When you have finished scanning all pages, press [Scanning End].