Muratec MFX-3510 Copier Guide

1
2
Advanced copy functions 2-15
Advanced copy functions
Scanning the next document
When you cannot load all the documents on the automatic document feeder or when you
want to scan multiple pages on document glass, use this setting to continuously scan
document of a large volume.
NOTE
The next document setting is enabled automatically at sorting (page 2-6) or card
copy (page 2-12), or at combine copy (page 2-7) or duplex copy (page 2-9) when the
document is loaded on the document glass.
1
Load the document.
2
Press the mode change key to change to copy mode.
3
Press <Advanced>.
4
Select “Next Doc.”, and press [Enter].
5
Select the device to enable next document scanning, and press [Enter].
•“ADF” stands for automatic document feeder.
•“FBS” stands for document glass (flat bed scanner).
6
Select “ON”, and press [Enter].
Select “OFF” to deselect the setting.
7
Press [Close] until you return to the ready screen.
8
Press <Start>.
When the documents have been scanned, the message “Set next document.” is displayed.
9
Load the next document to scan.
10
Press [Scan NextPage] or <Start>.
If you want to scan another document, repeat steps 9 and 10.
11
When you have finished scanning all the documents, press [Scanning End].

Muratec MFX-3510 Specifications

General

Brand	Muratec
Model	MFX-3510
Category	Copier
Language	English