Murex Transarc 250 - Mains Power Supply

-- 7 --
bh36d1ea
5.3 Mains power supply
Make sure that the welding power source is connected to the correct supply voltage
and that it is protected by the correct fuse rating. A protective earth connection must
be made in accordance with regulations.
Rating plate with supply connection data
5.3.1 Recommend ed fuse sizes and minimum cab le area
T ransarc 250
Mains voltage 400V
Mains cable area mm
2
4G1.5
Phase current I
1eff
8A
Fuse
anti--surge
type C MCB
10 A
10 A
NOTE!
The cable area and fuse rating above comply with Swedish regulations. Use the welding power source
in accordance with the relevant national regulations.
GB