22 Instruction manual – MU-C/S
Maintenance
• The mulcher should be inspected regularly for outward signs of damage and defects. This
applies especially to cutting flails and their mountings, and drive belts which should be
checked for signs of breaks, cracks, or excessive wear and tear.
• Replace immediately all cutting flails and mountings that show any signs of damage or are
cracked or heavily worn! If a cutting tool or mounting breaks during use, parts could fly out
and cause injury. When replacing parts use original Müthing spares!
• When maintaining, servicing and cleaning the machine, or correcting faults it his essential to
have the drive switched off and the engine stationary! - Remove the ignition key and ensure
the handbrake is on!
• Check nuts and bolts regularly to ensure that they fit properly and retighten them as
necessary!
• If you are carrying out maintenance work on a mulcher in the raised position always make
sure that you use suitable supports and that the rotor is stationary!
Never work under
unsupported loads !
• When changing implements with cutting edges always use suitable tools and gloves!
• Oil, grease and filters should be properly disposed of!
• Always isolate the current before working on the electrical system!
• Disconnect generator and battery cables before doing electrical welding work on the tractor
and mulcher!
• Spare parts must at least meet the specifications laid down by the equipment manufacturer!
This will always be the case if you use original spares!
To Next Page
Loading...