VJ-1638UH OPERATION MANUAL 6 Maintenance
6.6 Disposal the waste fluids 331
6.6 Disposal the waste fluids
The timing and method for the disposal of waste fluid are described below.
(1) Disposal timing
Dispose the waste fluids in the following cases:
a. When the waste fluid tank is more than half full.
b. When “Full WasteInkTank” is displayed on the operation panel.
(2) Disposal method
Follow the procedure below to dispose of waste fluid.
• The waste fluid from the printer is industrial waste.
Proper waste fluid disposal according to industrial waste disposal laws and
ordinances of your local government is required.
Consign disposal of waste fluids to a specialized processor.
• Waste fluid from this product is harmful to aquatic organisms. Avoid the waste fluid
from out flowing to sewage or natural water systems.
• For this operation, be sure to wear the supplied gloves (or solvent resistant gloves)
and goggles to prevent ink from contacting your eyes or skin.
Skin or eye contact with UV curable ink may cause skin inflammation or allergic
reaction.
• If ink gets on skin, immediately wash with soap and plenty of water for 15 minutes.
Seek medical advice/attention if irritation or inflammation are present.
• If ink gets in eyes, flush eyes with plenty of water for 15 minutes and seek medical
advice/attention immediately.
1. Ready an empty container such as a supply waste fluid bottle, to contain the waste fluid.
2. Lay a protective material on the floor under the waste fluid tank.
To Next Page
Loading...
