21
1. Connect the inverter to the battery.
2. Turn on the switch on the inverter panel.
3. Plug the remote control to enable remote functionality.
Please note of the following when using the wired remote control:
All buttons need to be pressed and held for 2-3 seconds to operate. If the
operation does not start after one attempt, please press the button again.
The switch on the inverter panel is the main power switch. Before using the
remote panel, please ensure that the power switch on the inverter control panel is
in the ON position. Otherwise, the inverter cannot be controlled by the wired remote
controller.
Our inverter is set to automatically turn o the screen within 15 seconds, and
you can press any buttons to turn it back on. The screen of the remote control
also consumes a certain amount of power. This setting is mainly to save power and
prevent the screen from consuming too much power.
Voltage-switching methord (From 110V to 120V):
- Step 1: Connect the remote control to the inverter and turn on the switch on the
inverter switch (not on the remote control).
- Step 2: Usually, when the inverter switch is turned on, the remote control will start
automatically. Then, press and hold the voltage switching button on the remote
control for about 2-3 seconds. The inverter will emit an alarm sound. This sound
indicates that the inverter is being recongured and does not indicate a malfunction.
- Step 3: With the alarm sound, press and hold the power button for 2-3 seconds.
This indicates the power-o operation.
- Step 4: After the alarm sound disappears, press the power button again for 2-3
seconds.
This indicates the power-on operation. This is equivalent to restarting the inverter
for successful voltage output switching. You can perform this switch without any
load and watch the voltage switch on both the display screen and the remote control.
Please note: The alarm sound during the operation does not indicate a malfunction.
If you are unable to understand the written instructions, please contact the ocial
email for video tutorials.
The specic steps for using the wired remote control:
To Next Page
Loading...
