MWXNE MW2000 - Electrical Safety

4
NEVER connect the AC output of the unit directly to an Electrical
Breaker Panel / Load Centre that is also receiving power from the utility
power / generator.
NEVER use the inverter with positive grounded electrical system. This
unit is designed for use with negative grounded electrical systems only.
ALWAYS ensure the inverter is o before connecting anything.
When connecting battery terminals, ensure that the polarity of the battery
connections is correct. Incorrect polarity may cause permanent damage
to the unit.
ALWAYS ensure the inverter is in the OFF position and all AC and DC
connections are disconnected before working on any circuit related to
the inverter.
Be careful when touching bare capacitor terminals as they may retain
high lethal voltages even after the power is removed.
Sparks may occur when connected to the battery. Combustible gas will
be generated during charging and discharging, so please ensure that the
surrounding is well ventilated, and do not store the inverter in a place
where ammable gas gathers.
DO NOT connect the output in parallel with the mains, otherwise it may
damage the inverter and cause electric shock hazard.
When using this inverter, DO NOT bundle wires together and use broken
wires, as this can cause electric shock, short circuits, or res.
DO NOT get the body wet, otherwise it may cause short circuit, re and
electric shock.
DO NOT place any stick items or other metal objects at any vent or
opening, as this could touch internal components and result in electric
shock or injury.
Make sure the device is fully plugged into the electrical socket. Failure
to fully insert the plug into the outlet may result in electric shock and
overheating, which may result in a re accident.
DO NOT use a damaged plug or loose socket. DO NOT touch the
machine with wet hands, otherwise it may cause electric shock.
KEEP AWAY FROM FIRE. Do not let volatile substances or combustible
substances oat into the machine. Please keep the machine away from
re.
DO NOT damage the output sockets or wires. Do not cut, modify, heat,
over-distort, twist or pull the cable, and keep the cable and receptacle it
from being subjected to heavy pressure, as this may result in an electrical
dangerous such as electric shock, re or short circuit.
Electrical Safety