24
The battery provides DC input voltage to the inverter, and its rated voltage
should match the rated input voltage of the inverter. Any voltage exceeding the
inverter input voltage range may cause inverter overload or damage.
In addition to voltage, the capacity of the battery (measured in amp-hours)
should match the power consumption of the load. Overload or undervoltage may
cause system failure or equipment failure.
Where high-power electrical equipment exceeds the limit of AC outlets, connect
the equipment to the hard-wired terminal, and ensure that the ground terminal of
the inverter is safely connected to the ground terminal of the equipment.
1. The inverter can use one or more batteries, but it is recommended to use a
battery with a capacity of 150AH or more.
2. Connect the inverter and battery with the included cables. Make sure all cables
are securely attached. Improper connections may cause cable overheating or
terminal breakage, which can shorten battery power supply time.
3. When the power switch is turned on, if the green LED lights up continuously, the
inverter and fully charged battery are properly connected. It works ne under load.
4. If the red LED light is on, it means that the inverter has automatically entered
protection mode.
Please check whether the battery voltage is too high or too low, or whether the
inverter output is overloaded or short-circuited by checking the fault status
displayed on the LCD.
The cause of the malfunction can be conrmed by the malfunction code displayed
on the LCD. If you have any questions, please feel free to contact us.
5. If you want to use a home appliance continuously, you can get a longer power
supply time by using one or more 12V batteries in parallel and using the AC power
of the 12V inverter.
6. This product has 12V, 24V, and 48V types. Make sure you use the correct type
you purchased.
7. The battery types applicable to this inverter include AGM, GEL, lithium-ion, SLD,
EFB, FLD, etc.
CAUTION
To Next Page
