Accepting Payments
Step1:
Step2:
Once your new D210 device is connected to the Internet and activated, it is
ready to accept payments with credit and debit cards.
Your D210 supports three different methods for accepting payments with
credit and debit cards - Magnetic Stripe, CHIP & PIN and Contactless (NFC).
For this purpose, the D210 incorporates two readers (right and bottom) and
one built-in antenna. The reader located at the right side of the device is
designated for swiping magnetic stripe cards, while the reader located at the
bottom is for CHIP cards. The antenna for contactless cards is located under
the display.
Sale Transaction
Every time you switch on your D210
terminal, it will automatically connect to
the Internet and will display the home
screen.
When you press the green key (O), the
terminal will go directly to the SALE screen
ready for performing a Sales transaction.
Making a SALE transaction with your D210
is easy and convenient. Please follow the 3
basic steps written below.
Enter the amount of the
transaction in the SALE Screen. The
amount must be entered without the
decimal point. For example: for an amount
of 5.00, enter 500 on the keyboard. When
the SALE screen display the correct
amount, confirm by pressing the green
key (O). If you need to correct the amount,
please use the yellow key (<) to delete the
last entry or the red key (X) to start the
process from the beginning.
Ask your customer for his or her
credit or debit card. If the card has a CHIP,
EN 14|
To Next Page
Loading...
