Nabco Opus Control Wiring And Programming Installation Manual

1 of 32
Opus Control Wiring and Programming
Installaon Manual
P/N C-00139 Rev 10-20-17
Nabco Entrances Inc. S82 W18717 Gemini Drive Muskego, Wisconsin 53150
Phone: (877) 622-2694 Fax: (888) 679-3319 www.nabcoentrances.com
NABCO hours of Operaon: Monday to Friday 8:00 a.m.- 4:30 p.m. (Central Time)
• Turn OFF all power to the Automatic Door if a Safety System is not working.
• Instruct the Owner to keep all power turned OFF until corrective action can be achieved
by a NABCO trained technician. Failure to follow these practices may result in serious
consequences.
• NEVER leave a Door operating without all Safety detection systems operational.
WARNING
Table of Contents
CHAPTER 1: SAFETY ............................................................. 2
CHAPTER 2: SCOPE .............................................................. 3
SECTION 2.1: To the Installer ......................................................................3
SECTION 2.2: Objecve ...........................................................................3
CHAPTER 3: FEATURES ........................................................... 3
CHAPTER 4: SPECIFICATIONS ..................................................... 3
SECTION 4.1 General Specicaons .................................................................3
SECTION 4.2 Electrical Specicaons ................................................................3
SECTION 4.3 Output Power Guidelines ..............................................................4
CHAPTER 5: 120 VAC GENERAL WIRING ............................................ 4
CHAPTER 6: THE OPUS CONTROL .................................................. 6
CHAPTER 7: THE ROTARY DIAL .................................................... 6
CHAPTER 8: LCD CATAGORY SCREENS .............................................. 7
SECTION 8.1: Level One: Specicaon Screens ........................................................7
SECTION 8.2: Level Two: Access Screen ..............................................................8
SECTION 8.3: Level Three and Four: Seng Category and Menu Items ....................................9
CHAPTER 9: COMMON PROGRAM ADJUSTMENTS .................................. 14
SECTION 9.1: Stroke Learning .....................................................................14
SECTION 9.2: Movement Sengs ..................................................................14
SECTION 9.3: Recycle Count “Reset”. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
CHAPTER 10: FOLD DOOR WIRING DIAGRAMS ..................................... 16
CHAPTER 11: SWING DOOR WIRING DIAGRAMS .................................... 18
CHAPTER 12: TROUBLESHOOTING ................................................29
SERVICE PARTS: OPUS SIDE LOAD UNITS ........................................... 31
SERVICE PARTS: OPUS BOTTOM LOAD UNITS ....................................... 32

Nabco Opus Control Specifications

General

Brand	Nabco
Model	Opus Control
Category	Controller
Language	English