Nabco Opus Control Wiring And Programming Installation Manual

16 of 32
Opus Control Wiring and Programming Installaon Manual www.NabcoEntrances.com
P/N C-00139 Rev 10-20-17
CHAPTER 10: FOLD DOOR WIRING DIAGRAMS
SECTION 10.1: Switches and Sensors
DN 1341
1 12VDC +12VDC 2GND Common for 12V and Signals
361Interior Ac va on
462Exterior Ac va on/Programmable Input
56BSwing Door Con nuous Safety (door mounted, swing side Safety Sensor)
Slide Door Holding Beam
6SWL Swing Door Safety with Lockout (overhead, swing side safety sensor)
Slide Door Sidelite Sensor
7Out1Programmable Output
8 BA
Break-out, Used mainly for sliding doors, can be used for ON/OFF with swing doors.
9 SQ Sequential activation. Signal to open, Signal to close.
10 H Programmable input 11
M0 Mode 0, When grounded, puts door into "One-W
ay" Mode, ("Hold-Open" when grounded with M1)
12 M1 Mode 1, When grounded, puts door into "Night" Mode, ("Hold-Open" when grounded with M0
)
13 Out2 Aux. Output 2, Programmable output, closes to GND
14 GND Ground (common) for all above signal
s
ROCKER SWITCH
ONE WAY
AUTO
ON
OFF
HOLD OPEN
A-01048
1413121110
98
N.O. BREAK-OUT SWITCHES
RED to pin 14
WHITE to pin 12
BLUE to pin 8
BLACK to pin 11 on Opus
1
2
3
4
5
ACUVISION
ACUSENSOR
FOLD SIDE
APROACH SIDE
FOLD SIDE
RED
WHITE
BLACK
GREEN
RED
BLUE
BROWN
WHITE
14-10823-01
ACUSENSOR HARNESS
M-01167
ACUVISION HARNESS
M-01730
14-8902
ACUSENSOR
14-8902
ACUSENSOR HARNESS
M-01167
RED
WHITE
BLACK
GREEN
1
2
2 3
1
2
2 4
1
2
2 6
To Pin # on Opus Control
7
6
54
321

Nabco Opus Control Specifications

General

Brand	Nabco
Model	Opus Control
Category	Controller
Language	English