Need help?Do you have a question about the NAD C 298 and is the answer not in the manual?
General| Power Output (8Ω) | 185 W |
|---|---|
| Signal-to-Noise Ratio (A-weighted) | > 120 dB |
| Input Impedance | 20 kΩ |
| Damping Factor (20Hz-6.5kHz, 8Ω) | >800 |
| Power Consumption (Standby) | <0.5W |
| IHF Dynamic Power into 4 Ohms | 400 W |
| Gain | 29 dB |
| THD (20 Hz - 20 kHz) at 1W | <0.002 % |
| Frequency Response | 20Hz - 20kHz |
| Input Sensitivity | 1.4V |
| Rated Power into 4 Ohms | 340W |
Introduction to the NAD C 298 Stereo Power Amplifier and its manual.
Safety rules covering operation, cleaning, attachments, water, accessories, and placement.
Instructions for service, battery disposal, and explanation of warning symbols for safe use.
Information on environmental protection and proper disposal of waste batteries.
Basic instructions for connecting and powering up the NAD C 298 amplifier.
Guidance on proper installation, ventilation, and saving original packaging.
Details on front panel buttons, indicators, and their functions like Standby and Power.
Description of Balanced, Single-Ended inputs and the Input Select switch.
Explanation of Line Out, Input Level control, and Auto Sense Level settings.
Details on power switch, trigger inputs/outputs, and fuse holder location.
Instructions for connecting speakers and using the Bridge Mode switch.
Detailed technical specifications for audio inputs and outputs.
Physical dimensions and weight of the NAD C 298 amplifier.
To Next Page
