NAD C 558 User Manual

SETUP
ASSEMBLY AND INSTALLATION
TRANSPORT SCREWS
Remove the three transport screws (12) from the top part of the chassis
before installing the sub-platter (11), the drive belt (10) and the platter (2).
NOTE
The transport screws are used to ensure safe shipping and transport,
and should be reinstalled prior to any future shipment or transportation
of the turntable.
PLATTER, SUB-PLATTER AND DRIVE BELT INSTALLATION
Remove the protective cover from the sub-platter (11).
Install the sub-platter (11) and the drive belt (13) as shown in the following
illustrations.
Install the platter (2) on the sub-platter (11) and screw the Record clamp
(19) with LP on the platter.
ADJUSTING THE PULLEY HEIGHT
In rare instances, you may have to adjust the pulley height if it taps against
the platter:
Carefully remove platter and drive belt from the turntable. Using a small
athead screwdriver, loosen the small screw and move the pulley to the
desired position.
Tighten the screw back and t the drive belt and the platter.
TONEARM ASSEMBLY
The tonearm includes a combination of cardan bearings in horizontal axle
and Japanese ball bearings in vertical axle.
See the next steps to set up your tonearm.
1 CARTRIDGE INSTALLATION
If you purchased this turntable in a package that included the cartridge,
this has already been done for you.
Install the cartridge into the aluminium headshell, using the
appropriate hardware included with your cartridge.
Connect the cartridge as indicated below:
• White left channel L+
• Red right channel R+
• Green right channel R-
• Blue left channel L-
For correct cartridge alignment, use the two-point cartridge alignment
protractor provided with your C-Sharp accessories. If unfamiliar with
two-point setup, please refer to your dealer.
2 COUNTERWEIGHT ASSEMBLY
The counterweight has two separate parts:
The rst part is the counterweight itself. The second part is an
additional insert that enables optimal balancing of heavier cartridges.
The counterweight without the additional insert can balance cartridges
from 5 to 9 g. (The weight of the counterweight itself is 110 g.)
The counterweight with the additional insert can balance cartridges
from 9 to 17 g. (The weight of the counterweight with the additional
insert is 148 g.)
5
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

NAD C 558 Specifications

General

Type	Direct drive audio turntable
Operation	Manual
Product color	Black
Nominal speeds	33, 45 RPM
Output voltage	4 mV
Turntable speeds	33 RPM
Channel separation	22 dB
Signal-to-Noise Ratio (SNR)	68 dB
Frequency range	20 - 22000 Hz
Package weight	8000 g
AC adapter frequency	47/63 Hz
AC adapter input voltage	100 - 240 V
AC adapter output current	0.8 A
AC adapter output voltage	15 V
Power consumption (standby)	0.3 W
Power consumption (typical)	5 W
USB ports quantity	-

Weight and Dimensions

Depth	125 mm
Width	435 mm
Height	340 mm
Weight	5500 g