NAD C355BEE - Reference - Troubleshooting; Troubleshooting Common Issues

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No sound. Power AC lead unplugged or power not
switched ON.
• Check if AC lead is plugged in and power
switched ON.
•
Tape Monitor selected. • De-select Tape Monitor mode. •
Mute on. • Switch o Mute. •
Rear Pre-out/Main-in amp links not tted. • Fit links. •
Headphones inserted. • Disconnect headphones. •
No sound one channel. Balance control not centered. • Center Balance control. •
Speaker not properly connected or damaged. • Check connections and speakers. •
Input lead disconnected or damaged. • Check leads and connections. •
Weak bass / diused stereo image. Speakers wired out of phase. • Check connections to all speakers in the
system.
•
Remote control handset not working. Battery at or incorrectly inserted. • Check or replace battery. •
IR transmitter or receiver windows obstructed. • Remove obstruction. •
IR receiver in direct sun or very bright ambient
light.
• Place unit away from direct sun, reduce
amount of ambient light.
•
Power / Stand-by / Protection LED turns red
during operation.
Amplier has overheated. • Turn amplier OFF; make sure ventilation
slots on top and bottom of amplier are not
blocked. After amplier has cooled down,
turn back ON.
•
Overall impedance of loudspeakers too low. • Ensure the overall loudspeaker impedance is
not below 4 ohms.
•
REFERENCE
TROUBLESHOOTING
11
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ