NAD C355BEE - Rear Panel

1 RS-232: Connect this interface via RS-232 serial cable (not supplied) to
any Windows® compatible PC to allow remote control of the C 355BEE
through NAD’s proprietary PC software or other compatible external
controllers. NAD is a certied partner of AMX and Crestron and fully
supports these external devices. See your NAD audio specialist for more
information.
2 12V TRIGGER OUTPUT: The 12V TRIGGER OUTPUT is used for
controlling external equipment that is equipped with a 12V trigger
input. This output will be 12V when the C 355BEE is ON and 0V when
the unit is either OFF or in standby. This output can drive a load up to
50mA at 12V.
3 IR IN/OUT: These mini-jacks accept and output remote-controlled
codes in electrical format, using industry-standard protocols, for use
with “IR-repeater” and multi-room systems and related technologies.
IR IN : This input is connected to the output of an IR (infrared) repeater
(Xantech or similar) or the IR output of another component to allow
control of the C 355BEE from a remote location.
IR OUT : When connected to the IR IN of an ancillary equipment, direct
the ancillary equipment’s own remote control to the C 355BEE’s infrared
receiver to command or control the linked unit.
All NAD products with IR IN/IR OUT features are fully compatible with
the C 355BEE. For non-NAD models, please check with your other
product’s service specialists as to their compatibility to the C 355BEE’s IR
features.
4 DISC INPUT: Input for additional line level input signals such as CD,
Mini Disc player or the output signal from a step-up amplier for a
turntable. Use a twin RCA-to-RCA lead to connect the auxiliary unit’s
left and right ‘Audio Outputs’ to this input.
NOTE
When a 3.5mm stereo plug is inserted into the Front Panel MP socket,
the indicator above the socket will illuminate, and the DISC line-level
source will be disconnected. It is recommended to mute the volume or
switch to a dierent input before plugging/unplugging the external
Media Player cable.
5 CD INPUT: Input for a CD or other line-level signal source. Use a
twin RCA-to-RCA lead to connect the CD player’s left and right ‘Audio
Outputs’ to this input. The NAD C 355BEE only accepts analogue signals
from your CD player.
6 VIDEO INPUT: Input for the audio signal from a stereo VCR (or stereo
TV/Satellite/Cable receiver) or other line-level audio source. Using twin
RCA-to-RCA leads, connect to the left and right ‘Audio Outputs’ of the
unit to these inputs.
NOTE
These are audio inputs only.
7 AUX INPUT: Input for additional line level input signals such as
another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary
unit’s left and right ‘Audio Outputs’ to this input.
8 TUNER INPUT: Input for a tuner or other line-level signal source.
Use a twin RCA-to-RCA lead to connect the tuner left and right ‘Audio
Outputs’ to this input.
IDENTIFICATION OF CONTROLS
REAR PANEL
1 2 3 4 5 6 187 8 9 10 11 12 13 14 15 16 17
ATTENTION!
Please make sure that the C 355BEE is powered OFF or unplugged before making any connections. It is also advisable to power-down or unplug all
associated components while making or breaking any signal or AC power connections.
7
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ