29
REMOTE CONTROL UNIT
CHECKING CODE-LIBRARY NUMBER
You can check the current code-library on any Device Selector key as follows. Enter Library Mode by
simultaneously pressing-and-holding for 3 seconds both the desired component's Device Selector key and
the "PROGRAM" key, until the Learn LED turns green. Press the "DISP" key; the HTR L76 indicates the
current code-library by flashing its "TAPE," "VCR," and "MACRO" keys.
For example, to indicate code-library #501 the HTR L76 will flash "TAPE" 5 times, pause, and then flash
"MACRO" once. You might wish to make a note of your components' code-library numbers.
SUMMARY OF HTR L76 MODES
Mode Keys To Press (for 3 seconds)
Learn/Copy/Punch Through Device Key + OPEN/CLOSE Key
Delete Mode Device Key + Return Key
Macro Record Macro Key + Function Key
Library Mode Device Key + Program Key
Back Light Timeout Display Key + Digit Key
Factory Reset (see “Factory Reset,” above)
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
To Next Page
Loading...
