Need help?Do you have a question about the NAD MONITOR Series and is the answer not in the manual?
Safety precautions for servicing the unit, including leakage tests.
Detailed specifications for the power amplifier stage.
Specifications for the amplifier when used in bridged mode.
Specifications for the preamplifier stage, including phono and line level inputs.
Specifications for audio outputs like preamp and tape.
Steps for calibrating the main amplifier: center voltage, idle current, and final adjustments.
Procedure for adjusting channel balance in the preamplifier.
Layouts for Input/Output, Main/Control/Supply, and Mains Input PCBs.
Layouts for Headphone, Power, and Bridge Switch PCBs.
Schematic and layout for the selector PCB.
Schematic and layout for the microcomputer PCB.
Schematic and layout for the tactile switch assembly.
Wiring diagrams for Input/Output, Main/Control/Supply, and Mains Input PCBs.
Wiring diagrams for Selector, Power, Bridge, Headphone, and Tactile Switch PCBs.
Electrical parts for Main/Control/Supply, Input/Output, and Selector PCBs.
Electrical parts for Mains Input, Tactile Switch, and µCom PCBs.
To Next Page
General
