NANO D-Series - RECOMMENDED TOOLS; DRYER SHUT DOWN PROCEDURE

Page 7
3. RECOMMENDED TOOLS
The following tools will be required to service the dryer:
TERMINAL SCREW DRIVER
ALLEN KEY 3mm
ALLEN KEY 4mm
ALLEN KEY 6mm
ALLEN KEY 8mm
TORQUE WRENCH (8-60NM)
TORQUE SOCKET 6mm
TORQUE SOCKET 8mm
20mm PIN SPANNER
BEARING PULLER
4. DRYER SHUT DOWN PROCEDURE
Before performing any maintenance or service operations on this product, ensure the product
is isolated from the compressed air supply and fully depressurised. Also ensure the product is
switched off and/or isolated from the mains power.
PROCEDURES
• Closetheinletandoutletvalves.
The dryer might still be pressurised! In order to depressurise the dryer; ensure the dryer is isolated from the
compressed air source:
o Cycle the dryer twice to ensure the dryer exhausts and is completely depressurised.
o When fully depressurised the ‘clicking’ of the exhaust valves will be heard but no air
exhausted.
• Whenthedryerisfullydepressurised,isolatefromthepowersupply.