NANO D2 - Operating the Dryer

10
heatless desiccant air dryer
D2
2.6 operation
Do not allow the unit to ow air unless switched on and cycling.
Resulting effect could be desiccant contamination; requiring a desiccant service.
• Ensure all pipe work is connected as per the typical layout
• The unit is connected with a power supply as stated on the rating label.
• Ensure the inlet air pressure is with in limits as stated on the rating label on the product.
• Ensure the inlet air temperature is with in limits as stated on the rating label on the product.
• Slowly open the inlet ow and allow the unit to pressurize
• Turn on the power to the unit, the unit will display its’ status.
• Allow the unit to cycle at least 2 times before slowly opening the outlet ow.
• In case of using the Remote Start/Stop function, ensure external voltage is active.
This unit must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. This unit is equipped with a cord having a grounding
wire with an appropriate grounding plug.
The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local
codes and ordinances.
Do not modify the plug provided; if it does not t the outlet, have the proper outlet installed by a qualied
electrician.
SERVICE LED
illuminated when
service required
DISPLAY PANEL
hours run/dewpoint
column a/b online
OPERATION LED
illuminated when
in operation