NAPCO Gemini GEM-P3200 User Manual

X GEM-P3200 Programming Instructions
L NAPCO Security Systems

Page 8
WI1184B 2/06
Enable No EOLR Zones (New Program Only)
• Press YES to program all zones except 24 Hr & fire zones for No End Of Line Resistor. Press NO to continue.
• Do not program this feature for UL Installations.
Enable Telco Line Fault Test?
• Press YES to enable Telco Line Fault Test.
• Press NO to continue. NOTE: If enabled, a Telco Line Fault Test Delay of 60 sec. will automatically be pro-
grammed.
Enable Burg Output Chirp on KeyFob?
• Press the NEXT/YES button to enable Burg Output Chirp on KeyFob Arm / Disarm.
• Press the PRIOR/NO button to continue.
NOTE: The Burg Output will chirp once on Keyfob Arm and twice on Keyfob Disarm.
Enable SIA CP-01 Features?
• Press the NEXT/YES button to enable.
• Press the PRIOR/NO button to continue.
The SIA CP-01 Features are designed to reduce the incidence of false alarms. NOTE: Do not enable unless re-
porting, otherwise system trouble Fail to Communicate may occur.
Number of Keypads in Area 1
• Enter the total number of Keypads to be installed in Area 1.
• Valid entries are from 01 to 15. Directly enter the number of keypads, including leading zeros.
Press
U to save. Press the NEXT/YES button to proceed.
Number of Keypads in Area 2
• Enter the total number of Keypads to be installed in Area 2.
• Valid entries are from 00 to 15. Directly enter the number of keypads, including leading zeros.
Press
U to save. Press the NEXT/YES button to proceed. NOTE: Area 2 keypads must have zones in Area 2,
otherwise the keypad will indicate "Out of System".
Central Station Receiver 1 Telephone Number
• Enter telephone number of up to 16 digits.
• Press 1 through 9 for digits 1–9; G 0 for a zero and 0 for a blank (•).
• Press G 1 through G 5 for letters B–F, respectively.
• Pre-Dial Delay = “D” (G 4); Dial-Tone Detection = “E” (G 5).
• Press U to save and press the NEXT/YES button to proceed.
NOTE: Central Station Receiver 2 and 3 Telephone Numbers must be en-
tered in Direct Address Programming. See CS Receiver Options.
(Press YES or NO)
EnNEOL
Y/N
(Press YES or NO)
Telco
Ln Flt
Y/N
(Press YES or NO)
KF Out
Chirp
Y/N
(Press YES or NO)
Enable
CP01?
Y/N
(Direct Entry)
Ent A1
#KP 01
(Direct Entry)
Ent A2
#KP 01
(Direct Entry)
Phone#
______
______
GEM-RP2ASE2/GEM-K2AS KEYPAD EASY PROGRAM MENU

NAPCO Gemini GEM-P3200 Specifications

General

Brand	NAPCO
Model	Gemini GEM-P3200
Category	Control Panel
Language	English