GEM-TOUCH K Style Keypad Operating Guide
27
E10-NNN -- Keypad Response Failure
Call installing company for service.
E11-NNN -- Keypad Tamper
The control panel has been opened,
or a wall-mounted keypad has been
opened and/or removed from the
wall. Call installing company for ser-
vice if problem cannot be repaired.
E15-NNN -- RF Transmitter Tamper
Wireless transmitter cover removed
(NN = transmitter number). Call in-
stalling company for service.
E16-NNN -- Wireless Receiver Jam
A problem has been detected with
the wireless receiver. Call installing
company for service.
E17-NNN -- Receiver Tamper Condi-
tion
Call installing company for service.
E18-NNN -- Keyfob Transmitter Low
Battery
A keyfob transmitter has indicated its
power cell(s) are weak and should be
replaced. The 4-button RR-
4BKEYFOB uses a 3V Lithium coin
cell battery (replace with type
CR2032 or Duracell DL2032 only).
The 1-button RR-1BUTTON uses
two Energizer 386 1.5V silver oxide
cells (the unit will also flash its LED to
warn of a low-battery). Warning:
Replace batteries only with the same
type as specified above. Use of an-
other battery may present a risk of
fire or explosion. Do not recharge or
disassemble battery, or dispose of in
fire.
E40-NNN -- RF Self-Test Failure
A wireless motion sensor on the zone
indicated has failed its automatic self-
test routine. Call installing company
for service.
E41-NNN -- Fire Trouble
A problem has been detected on the
fire zone indicated. Call installing
company for service.
E42-NNN -- CO Zone trouble
A problem has been detected on the
carbon monoxide zone indicated.
Call installing company for service.
E51 -- Bell/Siren Trouble
There is a problem with the bell or
siren. Call installing company for
service.
SYS TE M T RO UB LE ER RO R CO DE S ( c ont 'd )
To Next Page
Loading...
