EasyManua.ls Logo

Napoleon BIM605 - Lighting Instructions

Napoleon BIM605
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.napoleongrills.com
7
EN
O Posion
WARNING! Open lid.
WARNING! Ensure all burner controls are in the o posion. Turn on the gas supply valve.
Main Tube Burner Lighng Rear Burner Lighng
(Rosserie Burner)
(if equipped)
Side Burner Lighng
(If equipped)
1. Open grill lid. 1. Open grill lid. 1. Open side burner cover.
2. Push and turn any main burner knob
slowly to the ’hi’ posion. This acon
will ignite the pilot ame which will in
turn light the selected burner. If the
pilot lights, connue to push down on
the control knob unl the burner lights
and then release.
2. Remove the warming rack. 2. Push and turn side burner control to high
posion.
3. If the pilot does not ignite, then
immediately turn the control knob back
to the ‘o posion and repeat step 2
several mes.
3. Push and turn the rosserie burner control
knob slowly to the ‘hi’ posion. This acon
will ignite the pilot ame which will in turn
light the burner. If the pilot lights, connue
to push down on the burner control knob
unl the burner lights then release.
3. Press and hold igniter buon unl burner
lights, or light by match.
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob
to the ‘o’ posion and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
4. If the burner does not ignite, then
immediately turn the control knob back to
the ‘o’ posion and repeat step 3 several
mes.
4. If the burner will not ignite within 5
seconds, turn the control knob to the ‘o’
posion and wait 5 minutes for any excess gas
to dissipate. Either repeat steps 2 and 3 or
light with a match.
5. If lighng the unit with a match, clip
the match into the supplied lighng
rod. Hold the lit match down through
the grill and sear plate while turning the
corresponding burner valve to high.
5. If the burner will not ignite within 5
seconds, turn the control knob to the ‘o’
posion and wait 5 minutes for any excess
gas to dissipate. Either repeat steps 3 and 4
or light with a match.
WARNING! The propane cylinder is equipped with an excess ow device. Unless all burners are
turned o prior to turning the cylinder on, only small ames and low heat will be achievable.
WARNING! Do not use the rear burner (rosserie burner) with the main burners operang.
Lighng Instrucons
Lights
Le
Burner
Le Centre
Burner
Rear
Burner
Infra Red
Burner
Right Centre
Burner

Other manuals for Napoleon BIM605

Related product manuals