Napoleon BIPRO 825 - User Manual

Other manuals for Napoleon BIPRO 825

Instructions72 pages

Questions and Answers

J
Jessica JonesSep 8, 2025
What to do if my Napoleon BIPRO 825 burner output on high is too low?
- C
  Charles OrtegaSep 8, 2025
  If the burner output on your Napoleon grill is too low on the “high” setting, accompanied by a rumbling noise, here are some possible causes and solutions: 1. Lack of gas: Check the gas level in the propane cylinder. 2. Pinched supply hose: Reposition the supply hose as necessary. 3. Dirty or clogged orifice: Clean the burner orifice. 4. Obstruction in venturi tube: Clean out the venturi tube. 5. Propane regulator in “low flow” state: Ensure the lighting procedure is followed carefully. All gas grill valves must be in the off position when the tank valve is turned on. Turn the tank on slowly to allow pressure to equalize. See lighting instructions.
B
Benjamin McdonaldAug 23, 2025
How to fix low heat on my Napoleon Gas grill?
- R
  Rebecca DanielAug 23, 2025
  To address low heat or low flame on your Napoleon Gas grill when the valve is turned to high, ensure the lighting procedure is carefully followed. All gas grill valves must be in the off position when the tank valve is turned on. Turn the tank on slowly to allow pressure to equalize. Preheat the grill with both main burners on high for 10 to 15 minutes.
G
gyoungAug 25, 2025
What to do if my Napoleon Gas grill has excessive flare-ups?
- R
  riosamberAug 25, 2025
  To resolve excessive flare-ups or uneven heat on your Napoleon Gas grill, ensure the sear plates are installed correctly with the holes towards the front and the slots on the bottom. Preheat the grill with both main burners on high for 10 to 15 minutes. Clean the sear plates and drip pan regularly, and do not line the pan with aluminum foil.
J
James GoodAug 26, 2025
Why is the burner output on my Napoleon Gas grill too low?
- M
  Maria PageAug 27, 2025
  If the burner output on your Napoleon Gas grill is too low on the “high” setting, accompanied by a rumbling noise and fluttering blue flame at the burner surface, check the gas level in the propane cylinder and reposition the supply hose if necessary. Clean the burner orifice and venturi tube. Ensure the lighting procedure is followed carefully, with all gas grill valves in the off position when the tank valve is turned on, and turn the tank on slowly to allow pressure to equalize.
J
Joshua TorresAug 27, 2025
Why are the lights not working on my Napoleon Gas grill?
- E
  Emily Nielsen PhDAug 27, 2025
  If the oven and control panel lights on your Napoleon Gas grill are not working, plug the power cord into a working GFI protected outlet in the electrical box on the back of the grill and plug the transformer cord into the power box. Replace the fuse located on the outlet line of the transformer and check the transformer output, which should be 12VAC, and replace if required. Clean the connections and ensure connectors are pushed together firmly. Access to the circuit board is under the electrical cover on the left side of the cabinet. Replace the bulbs as per the instructions in the maintenance section of the manual.
Y
ysmithAug 29, 2025
Why is the electronic ignition not working on my Napoleon Gas grill?
- B
  Bruce WillisAug 29, 2025
  If the electronic ignition on your Napoleon Gas grill is not working, plug the power cord (from a working GFI protected outlet) into the electrical box on the back of the grill and plug the transformer cord into the power box. Replace the fuse located on the outlet line of the transformer and check the transformer output, which should be 12VAC, and replace if required. Clean the connections and ensure connectors are pushed together firmly. Access to the circuit board is under the electrical cover on the left side of the cabinet. Replace the igniter, located under the electrical cover. Clean or replace the electrodes as required.
W
williamdiazSep 18, 2025
What causes peeling "paint" inside my Napoleon BIPRO 825 Grill lid?
- B
  Bryan JonesSep 18, 2025
  The "paint" peeling inside your Napoleon grill lid is not a defect. The finish on the lid and hood is porcelain and will not peel. The peeling is caused by hardened grease, which dries into paint-like shards that flake off. Regular cleaning will prevent this. See the cleaning instructions.
M
Matthew FrancisSep 22, 2025
What causes Napoleon BIPRO 825 Grill burners to not cross light each other?
- G
  Gary RussellSep 22, 2025
  If the burners on your Napoleon grill will not cross light each other, it is likely due to dirty or corroded cross light brackets. Clean or replace the brackets as required.
E
erik37Sep 7, 2025
Why does my Napoleon Grill have excessive flare-ups or uneven heat?
- N
  Natalie MillerSep 7, 2025
  Excessive flare-ups or uneven heat in your Napoleon grill can be due to a few reasons: * Incorrect installation of sear plates: Ensure the sear plates are installed with the holes towards the front and the slots on the bottom. Consult the assembly instructions. * Improper preheating: Preheat the grill with both main burners on high for 10 to 15 minutes. * Excessive grease and ash buildup: Regularly clean the sear plates and drip pan. Do not line the pan with aluminum foil. Refer to the cleaning instructions.
E
Elizabeth ThompsonSep 4, 2025
Why won't the burners cross light on my Napoleon Gas grill?
- E
  Eric BerrySep 4, 2025
  If the burners on your Napoleon Gas grill will not cross light each other, clean or replace the dirty or corroded cross light brackets as required.