Napoleon BIPRO665RBPSS-3 User Manual (English)

Questions and Answers:

M
Micheal WelchAug 17, 2025
Why is there excessive flare-ups and uneven heat on my Napoleon Grill?
- E
  Elizabeth JohnsonAug 17, 2025
  Excessive flare-ups and uneven heat on your Napoleon Grill can be due to several reasons. Ensure sear plates are installed correctly with the holes towards the front and the slots on the bottom. Improper preheating can also cause this issue, so preheat the grill with both main burners on high for 10 to 15 minutes. Regularly clean the sear plates and drip pan to prevent excessive grease and ash build-up. Do not line the drip pan with aluminum foil.
A
antoniobuckleyAug 20, 2025
Why is the heat low on my Napoleon Grill when the valve is on high?
- W
  Wendy LeeAug 20, 2025
  Low heat or flame on your Napoleon Grill, even when the valve is turned to high, can occur due to a few reasons. For propane grills, ensure you follow the correct lighting procedure, with all gas grill valves in the off position when you turn on the tank valve, and turn the tank on slowly to allow pressure to equalize. For natural gas grills, the supply line might be undersized, so the pipe must be sized according to the installation code. For both types of grills, improper preheating can be a cause, so preheat the grill with both main burners on high for 10 to 15 minutes.
C
Cynthia StephensAug 22, 2025
What to do if the electronic ignition is not working on my Napoleon Grill?
- K
  kevin98Aug 22, 2025
  If the electronic ignition on your Napoleon Grill isn't working, check the following: 1. Ensure the unit is connected to a working GFI protected outlet. 2. Check and replace the fuse located on the outlet line of the transformer. 3. Verify the transformer output is 12VAC; replace if needed. 4. Clean any corroded or loose terminals on the switch or circuit board and ensure connectors are firmly pushed together. 5. Clean or replace dirty or corroded electrodes. 6. Replace the igniter if necessary.
D
David YoderAug 26, 2025
Why is the burner output too low on the high setting of my Napoleon BIPRO665RBPSS-3 Grill?
- B
  Brenda AllenAug 26, 2025
  If the burner output on the 'high' setting of your Napoleon Grill is too low, with a rumbling noise and flute ring blue flame at the burner surface, it could be due to several factors: * Check the gas level in the propane cylinder. * Reposition the supply hose if it is pinched. * Clean the burner orifice and venturi tube. * Ensure you are following the correct lighting procedure, with all gas grill valves off when turning on the tank valve, and turning the tank on slowly to equalize pressure.
J
jfloydAug 28, 2025
Why are the oven and control panel lights not working on my Napoleon BIPRO665RBPSS-3 Grill?
- C
  Carol FernandezAug 28, 2025
  If the oven and control panel lights on your Napoleon Grill are not working, check the following: * Ensure the unit is connected to a working GFI protected outlet. * Check and replace the fuse located on the outlet line of the transformer. * Verify the transformer output is 12VAC; replace if needed. * Clean any corroded or loose terminals on the switch or circuit board and ensure connectors are firmly pushed together.
A
Amy HarringtonAug 30, 2025
Why do the burners on my Napoleon BIPRO665RBPSS-3 Grill have a yellow flame and smell of gas?
- N
  Nichole WilsonAug 30, 2025
  If the burners on your Napoleon Grill are burning with a yellow flame and there is a smell of gas, it may be due to a spider web or other debris in the burner, or an improper air shutter adjustment. Thoroughly clean the burner by removing it. The air shutter should be opened slightly according to combustion air adjustment instructions; this adjustment must be done by a qualified gas installer.
F
Fernando HaynesSep 2, 2025
What to do if the infrared burner flashes back on my Napoleon BIPRO665RBPSS-3?
- M
  Maria MullinsSep 2, 2025
  If the infrared burner on your Napoleon Grill flashes back, making a loud 'whoosh' sound and growing dim, it could be due to: * Ceramic tiles overloaded with grease. * Clogged ports. Turn the burner off and let it cool for two minutes, then relight and burn on high for five minutes until the tiles glow red. Ensure that no more than 75% of the grill surface is covered. If the issue persists, inspect the ceramic tiles for cracks after cooling. Contact your Napoleon dealer for a replacement if needed.
K
kellerbrianSep 5, 2025
Why are the flames lifting away from the burner on my Napoleon BIPRO665RBPSS-3 Grill?
- A
  Ana GomezSep 5, 2025
  If the flames on your Napoleon Grill lift away from the burner, accompanied by the smell of gas, and you're experiencing lighting difficulties, this is due to improper air shutter adjustment. Close the air shutter slightly according to combustion air adjustment instructions. This adjustment must be done by a qualified gas installer.
K
Kimberly ShieldsSep 8, 2025
Why does the 'paint' appear to be peeling inside the lid of my Napoleon Grill?
- P
  pamelablairSep 8, 2025
  If what appears to be paint is peeling inside the lid or hood of your Napoleon Grill, it is not a defect. The finish is porcelain and will not peel. The peeling is hardened grease that has dried into paint-like shards. Regular cleaning will prevent this.
R
Roberto WeaverSep 12, 2025
What to do if the main burner won't light with the igniter on my Napoleon BIPRO665RBPSS-3 Grill?
- L
  Laura SextonSep 12, 2025
  If the main burner on your Napoleon Grill will not light with the igniter but lights with a match, the jet-fire outlet is likely dirty or clogged. Clean the jet-fire outlet with a soft bristle brush.

Napoleon BIPRO665RBPSS-3 Specifications

General

Model	BIPRO665RBPSS-3
Category	Grill
Fuel Type	Propane or Natural Gas
BTU Output	60, 000 BTU
Rotisserie Burner	Yes
Infrared Burner	Yes
Material	Stainless Steel
Infrared Side Burner BTU	12, 000 BTU
Grill Material	Stainless Steel
Ignition	Electronic
Type	Gas
Total Cooking Area	665 sq in
Rear Burner	Infrared
Side Burner	Infrared
Primary Burner	Stainless Steel