Troubleshoong
Problem Possible Causes Soluon
Low heat / Low ame
when valve turned to
high.
Blockage of gas.
Improper preheang.
Cylinder freezing up.
Check for spider webs in the burner or orice.
Preheat grill with main burners on high for 5 to
10 minutes.
When cooking for long periods of me, or
when the cylinder is close to being empty, or
low outside air temperatures, 1 lb cylinders do
not have enough weed surface area to allow
liquid propane to turn to vapour. Put on a fresh
1 lb cylinder or hook-up to a 20 lb tank.
Excessive are-ups/
uneven heat.
Improper preheang.
Excessive grease and ash build up in
drip pan.
Preheat grill with both main burners on high for
5 to 10 minutes.
Clean drip pan regularly. Do not line pan with
aluminum foil. Refer to cleaning instrucons.
Burners burn with yellow
ame, accompanied by
the smell of gas.
Possible spider web or other debris,
or improper air shuer adjustment.
Thoroughly clean burner by removing. See
general maintenance instrucons. Open air
shuer slightly according to combuson air
adjustment instrucons. (This must be done by
a qualied gas installer.)
Flames li away from
burner, accompanied
by the smell of gas, and
possibly dicules in
lighng.
Improper air shuer adjustment. Close air shuer slightly according to
combuson air adjustment instrucons. (This
must be done by a qualied gas installer.)
Burner will not light with
the igniter, but will light
with a match.
Jet-re outlet is dirty or clogged.
Clean jet-re outlet with a so bristle brush.
“Paint” appears to be
peeling inside lid or hood.
Grease build-up on inside surfaces. This is not a defect. The lid and hood are
stainless steel, and will not peel. The peeling
is caused by hardened grease, which dries into
paint-like shards that ake o. Regular cleaning
will prevent this. See cleaning instrucons.
Burner output on “high”
seng is too low.
(Rumbling noise and
uering blue ame at
burner surface.)
Lack of gas.
Supply hose is pinched.
Dirty or clogged orice.
Spider webs or other maer in
venturi tube.
Check gas level in propane cylinder.
Reposion supply hose as necessary.
Clean burner orice.
Clean out venturi tube.