5 Operation and use ELT-400
5-8
The display shows the error message “noPr”.
The probe is not connected or has not been detected by the instrument.
⇒ Remove the probe and reconnect it.
ª Connecting / disconnecting the B field probe: see page 3-4
The display shows the error message “unPr”.
The unknown probe has been connected.
⇒ Connect the correct probe.
ª Connecting / disconnecting the B field probe: see page 3-4
5.3.2 Selecting the operating mode (MODE)
The operating modes implemented in the instrument are shown below the
display.
ª Operating modes: see page 5-1
⇒ Press the MODE key until the arrow symbol in the display points to the
required operating mode.
Note: The measurement display will fluctuate whenever the setting is
changed. This fluctuation depends on the selected lower
frequency range limit and may continue for several seconds,
particularly if 1 Hz or 10 Hz is selected. Wait until the display has
settled before starting measurements.
To Next Page
Loading...
