7 Remote control ELT-400
7-2
Connecting the instrument to the measurement computer
1. Plug the jack plug into the “RS-232” socket on the ELT-400.
2. Plug the DB9 plug into the serial interface connector (COM) of the
measurement computer.
7.1.2 Interface parameters
✓ The ELT-400 is connected to the PC.
The following parameters must be set for the serial interface of the
computer:
• Baud rate: 19200
• 1 start bit
• 8 data bits
• No parity
• 1 stop bit
• Handshake: XON/XOFF
To Next Page
Loading...
